MAKEPCB1.txt
VIEW/FIX PROTEL TYPE ARTWORKS ready for LASER Printing
(EASYTRAX, AUTOTRAX, TRAXMAKER, PfW 2.8, PfW 98/99)

In this part of the cycle, we need to view, the proposed artwork be-it
PROTEL EASYTRAX, AUTOTRAX, PROTEL for WINDOWS 2.8, TRAXMAKER

Now this should have been finished some weeks earlier and even emailed
to RCS prior to ok, for brickbats and bouquets, ready to go.

We can convert and view any of the above common Industrial CAD "packages"

I am biased to the point that to use anything other than Protel is an act
of ignorance and stupidity, yeh, I know the libraries are rubbish but you
have the ability to make your own, (unlike smARTWORK) and the colours on
Protel are back to front, but you can setup correct this, (BOTTOM Solder
Layer = RED and TOP Component Layer trackwork is supposed to be BLUE,
please no discussion on this matter, (If you have it the other way around
then you are WRONG as per US Standards 275 - World Standards or later)

Anyhow, this section is where we view, correct and amend if needed 
prep the 'master a/w' prior to Positive Clear Film printouts.

end of MAKEPCB1.txt