41 Arlewis st.  CHESTER HILL   2162

This service is only held on the 3rd Saturday of the month,
So please Telephone a book in slot, before 'dropping' in.

Telephone No. for any book in    (o2) 9738-0330

mobile : 0404-RCS-RCS         email : rcs radio

The purpose of this page is to assist/inform you as to 'HOW TO'
make a Circuit Board, you are welcome, by pre-telephone call
to organise a 'drop in' for look see, one day through the week,
or book in a time on one saturday and actually MAKE a BOARD.

If you do not have a 'PROTEL' file, then 'YOU' can make a 1:1 'scaled' clear
OHP film, off a LASER Printer and a Single Sided Board, 'CAN BE MADE'
But Do NOT fall into the same trap, as one very young naive 'new kid did'
and try to 'order' me to make a 'PTH' board off an unscaled 'PDF'
file from an overseas, Italian Web site, (plus viruses), hmmmmm.

read on for "the saga"

...

Protel was a very small Tas. CAD software company of  'circa 1980's',
Anything from Protel 99, 98, 2.8, Traxmaker, Autotrax, Easytrax etc
The beauty of Protel is that it can be converted  99>Easytrax>99
The defacto standard for industry is PfW 2.8, but us oldies use Autotrax